Specifications

DeTOS 7 Administration Manual
14
4.1.2 Dual Monitors (Thin Clients Only)
This section describes how to set up and configure dual monitors*.
1. While the unit is turned off, attach both monitors to the terminal. If using the TC5c thin client, use the provided
VGA-DVI combination splitter on the DVI port in the back, and attach both monitors to the splitter.
2. Turn on the terminal.
3. Upon bootup, the display will be mirrored on both monitors.
4. From the DeTOS Desktop, select DeTOS → DeTOS Control Panel.
5. Click the Display icon on the left hand side of the Control Panel, under System.
6. You will be presented with display settings for Color Depth and Screen Blanking options. These settings
apply to both monitors associated with the DVI-1 (bottom) port and the LVDS1 represents the DVI-2 (top) port..
7. To adjust specific properties for each monitor, click the Monitors button along the top of the Control Panel. You
will then be presented with the names of the two monitors attached to the terminal. The exact names will vary
depending on how they are detected on that particular terminal. For a TC5 thin client, the VGA1 port is typically
associated with the DVI-1 (bottom) port and the LVDS1 represents the DVI-2 (top) port.
8. Click one of the monitor names from the list. This will open a configuration screen that contains Resolution,
Position, Rotation, and Reflection properties for that specific monitor.
*Note: At this time, dual monitors only apply to DeTOS based thin clients. VDI Blaster PCs will only support single display.