Technical data

18 Initial use
devolo dLAN TV SAT Multituner Kit
Please note that all dLAN devices to be
connected to your network are also
connected to your household electrical
wiring. A dLAN device switches into
standby mode after a short time if no
network device (such as a computer)
connected to the network interface is
switched on. In Standby mode, the
dLAN device cannot be accessed via
the power supply grid. As soon as the
network device (e.g. computer) con-
nected to the network interface is
switched on again, your dLAN device
can also be reached again via the elec-
trical wiring.
3.4.2 Connecting the dLAN adapter
This section describes how to connect your dLAN
adapter to Wi-Fi Internet access device.
햲 Use the included network cable to connect the
dLAN adapter to the network port of your Wi-Fi
Internet access device.
햳 Plug the dLAN adapter into a free electrical outlet.
Additional network devices that are connect-
ed via a multiple socket are connected to the
mains power supply by plugging the multiple
socket into the integrated electrical socket of
the dLAN adapter.
햴 Once you have connected at least two dLAN
devices (see also 3.3.3 Connecting the
dLAN TV SAT Multituner), your dLAN network
has been set up. To secure your dLAN network,
continue with the configuration as described in
chapter 6 dLAN network.
3.5 Installing devolo software
3.5.1 Software for Windows
devolo dLAN Cockpit finds all reachable dLAN adapt-
ers in your dLAN network, displays information about
these devices and encrypts your dLAN network individ-
ually.
To install the software, insert the included CD-ROM in
the CD drive of your computer. This has to be connect-
ed to the dLAN network by an additional dLAN
adapter.