Technical data

|
devolo MicroLink dLAN Software
13
|
devolo MicroLink dLAN Highspeed Ethernet
|
3.4 Overview in the dLAN network with the
MicroLink
Informer
Due to the MicroLink Informer you always have an overview of all dLAN
adapters in your dLAN network. The MicroLink
Informer shows the dLAN
adapter connected directly to the computer as well as all dLAN adapters that
are included into the same dLAN network.
The MicroLink Informer displays information about all dLAN devices in your
network, such as their MAC addresses for dLAN and current transfer speeds.
Via
Device  Rename you can change the name of the selected device.
Right-clicking on one of the dLAN adapters opens a context menu in which
the following commands are available:
 'Rename' opens a dialog in which you can assign a new name to the
device.
 'Start dLAN configuration wizard' opens a dialog in which you can add
new dLAN adapters to the dLAN network and assign the network pass
-
word.
MicroLink Informer displays only those dLAN adapters that are connected to
the power supply and added to your dLAN network. After about 15 minutes,
a dLAN adapter switches into stand-by mode unless there is an active device
connected to the Ethernet interface. dLAN adapters in stand-by mode are not
shown in MicroLink
Informer.