Operation Manual

7
Installing the Home Control Room Thermostat
If installing to a wall using screws, make sure that no gas, water or power lines in
the wall get damaged. There is a danger of electric shock!
Only use the Home Control Room Thermostat indoors.
햲 Disconnect the housing backplate, which also acts as both a holder and battery compartment cover,
from the device by pushing it down and away.
햳 Then, based on the template on the housing backplate, drill holes into the desired location and attach
the housing backplate in the correct mounting position using the included screws.
햴 Remove the black battery tab inside the Home Control Room Thermostat to establish battery contact.