Home Control Room Thermostat first steps
Thank you for placing your trust in this devolo product. Carefully read all instructions before setting up the device and store the instructions for later reference. Icons Very important note. Failure to observe this note may result in damage. Important note that should be observed. Background information and configuration tips for your device. Intended use Use the Home Control Room Thermostat as described in these instructions and in the Home Control online help to prevent damage and injuries.
devolo Home Control Home Control (also known as home automation) refers to the specific control of electrically operated indoor household devices. The Home Control system by devolo uses the Z-WaveTM wireless standard. A Home Control system requires a Z-WaveTM-compatible control unit such as the Home Control Central Unit from devolo. Use its Home Control portal to coordinate the Home Control Room Thermostat and all other Home Control devices.
The Home Control Room Thermostat Room temperature is controlled electronically, e.g. via the Home Control Central Unit (see section devolo Home Control on page 3) or manually via the navigation buttons on the thermostat. In the latter case, the Home Control Room Thermostat sends a change notification to the control unit, e.g. the Home Control Central Unit.
Batteries Always keep batteries away from open flame and high temperatures. Avoid direct sunlight and radiant heat! Always remove all batteries from battery-operated devices that are only in storage and are not in use. Old batteries can leak and damage the device! Do not use rechargeable batteries! When inserting the batteries, ensure that the polarity is correct. Using the batteries incorrectly can damage the device! The Home Control Room Thermostat uses commercially available AA alkaline batteries.
Installing the Home Control Room Thermostat If installing to a wall using screws, make sure that no gas, water or power lines in the wall get damaged. There is a danger of electric shock! Only use the Home Control Room Thermostat indoors. 햲 Disconnect the housing backplate, which also acts as both a holder and battery compartment cover, from the device by pushing it down and away.
햵 Then slide the Home Control Room Thermostat from above onto the housing backplate fastened on the wall.
Registering the Home Control Room Thermostat on the control unit (e.g. Home Control Central Unit) 햶 After you have successfully installed the Home Control Room Thermostat, continue with its electronic registration on the control unit. 햷 When you plug in the Home Control Central Unit from devolo, follow the description in the section devolo Home Control on page 3 to call up your Home Control Central Unit and select Devices Add device devolo Home Control Room Thermostat.
Service and warranty Warranty: 3 years If your devolo device is found to be defective during initial installation or within the warranty period, please contact the vendor who sold you the product. The vendor will take care of the repair or warranty claim for you. The complete warranty conditions can be found at www.devolo.com/warranty. Great Britain 0203 024 18 38 (national rate) support@devolo.co.uk Sweden 0077 1400 480 (national rate) support@devolo.
40964/0115 devolo AG Charlottenburger Allee 60 52068 Aachen – Germany www.devolo.
