Operation Manual

If installing to a wall using screws, make sure that no gas, water or power lines in

the wall get damaged. There is a danger of electric shock!

햶 If you are using screws to fasten the Home Control Wall Switch, first disassemble the

Home Control Wall Switch into the illustrated individual parts (see figure on left on page 6) by prising the

board out of the two holders.

쑗 Then, based on the template on the housing backplate, drill holes into the desired location and

attach the housing backplate using screws.

When mounting the housing backplate, make sure that the "TOP with up arrow"

marking in the upper right corner for the mounting direction points up so that the

switch order 1-2-3-4 is correct.

쑗 First connect the frame to the housing backplate and then the board according to the board holder

and the "TOP with up arrow" marking.

쑗 Then attach the desired rocker switch(es) into the board of the Home Control Wall Switch. This com-

pletes the installation of the Home Control Wall Switch.

From now on, you can take electronic control conveniently using the Home Control portal of the

Home Control Central Unit.

For more information on how to control and configure all devolo Home Control devices, as well as

for application examples, please refer to the Home Control online help.