Operation Manual

쑗 Based on the template on the lower housing component of the magnet, drill holes at the

desired installation location on the window frame or door frame (distance of magnet to sensor

< 2 cm), and then attach the lower component of the magnet using screws.

The notches on the magnet and of the sensor should line up with one another.

쑗 To close the sensor housing, first insert the lower end of the upper housing component of the

sensor into the corresponding groove

 in the lower housing component of the sensor and

then press the entire upper housing component, (from bottom to top,

 and ) onto the lower

component until it clicks into place.

쑗 To close the magnet housing, insert the upper housing component of the magnet until it clicks

into place onto the lower housing component of the magnet. This completes the installation of

the Home Control Door/Window Contact.

From now on, you can take electronic control of the devices conveniently using the

Home Control portal of the Home Control Central Unit.

For more information on the control and configuration of all devolo Home Control devices, as well

as application examples, please refer to the Home Control online help.