Home Control Radiator Thermostat first steps
Thank you for placing your trust in this devolo product. Carefully read all instructions before setting up the device and store the instructions for later reference. Icons Very important note. Failure to observe this note may result in damage. Important note that should be observed. Background information and configuration tips for your device. Intended use Use the Home Control Radiator Thermostat as described in these instructions and in the Home Control online help to prevent damage and injuries.
devolo Home Control Home Control (also known as home automation) refers to the specific control of electrically operated indoor household devices. The Home Control system by devolo uses the Z-WaveTM wireless standard. A Home Control system requires a Z-WaveTM-compatible control unit such as the Home Control Central Unit from devolo. Use its Home Control portal to coordinate the Home Control Radiator Thermostat and all other Home Control devices.
The Home Control Radiator Thermostat The radiator is controlled electronically, e.g. via the Home Control Central Unit (see section devolo Home Control on page 3 or manually via the function button and the navigation buttons on the thermostat. In the latter case, the Home Control Radiator Thermostat sends a change notification to the control unit, e.g. the Home Control Central Unit.
Removing the existing thermostat To ensure that the radiator valve is accessible for the installation of the Home Control Radiator Thermostat, remove the old thermostat or (for a new radiator) the protective cap. Depending on the type, thermostats are removed differently; some are simply unscrewed, while others have to be detached using a standard tool. For more information, refer to the respective manufacturer's documentation.
햲 Take off the battery compartment cover and insert the included batteries in the correct position (see marking in the battery compartment) into the Home Control Radiator Thermostat. 햳 When you have inserted the batteries correctly, the following symbol flashes on the display of the Home Control Radiator Thermostat. 햴 Reattach the battery compartment cover. You can now continue with the installation on the radiator.
쎲 The narrow adapter ring is compatible with the M30 x 1.5 screw threads from the following manufacturers: Comap/SAR, Heimeier, Honeywell-Braukmann, Idmar, Jaga, Junkers, MNG, Orkli, Oventrop, Pegler, R.B.M., Rossweiner, Schlösser, Siemens, Simplex, Tieme, Valv Sanayii, Watts. 쎲 The wide adapter ring is compatible with all Danfoss RA valves.
햷 To fasten the Home Control Radiator Thermostat completely, press the centre function button for 3 seconds . The device pulls tight on its own and is thus completely installed. Registering the Home Control Radiator Thermostat on the control unit (e.g. Home Control Central Unit) 햸 After you have successfully installed the Home Control Radiator Thermostat, continue with its electronic registration on the control unit.
Service and warranty Warranty: 3 years If your devolo device is found to be defective during initial installation or within the warranty period, please contact the vendor who sold you the product. The vendor will take care of the repair or warranty claim for you. The complete warranty conditions can be found at www.devolo.com/warranty. Great Britain 0203 024 18 38 (national rate) support@devolo.co.uk Sweden 0077 1400 480 (national rate) support@devolo.
40960/0115 devolo AG Charlottenburger Allee 60 52068 Aachen – Germany www.devolo.
