Home Control Motion Sensor first steps
Thank you for placing your trust in this devolo product. Carefully read all instructions before setting up the device and store the instructions for later reference. Icons Very important note. Failure to observe this note may result in damage. Important note that should be observed. Background information and configuration tips for your device. Intended use Use the Home Control Motion Sensor as described in these instructions and in the Home Control online help to prevent damage and injuries.
devolo Home Control Home Control (also known as home automation) refers to the specific control of electrically operated indoor household devices. The Home Control system by devolo uses the Z-WaveTM wireless standard. A Home Control system requires a Z-WaveTM-compatible control unit such as the Home Control Central Unit from devolo. Use its Home Control portal to coordinate the Home Control Motion Sensor and all other Home Control devices.
The Home Control Motion Sensor The Home Control Motion Sensor measures brightness and temperature. Detects movements in an angle of 80 degrees horizontally and in a distance of up to 8 metres. The integrated light sensor can also be an impulse transmitter for the light controls. Furthermore, the Home Control Motion Sensor has an integrated LED and a release button.
Batteries Always keep batteries away from open flame and high temperatures. Avoid direct sunlight and heat radiation! Always remove all batteries from battery-operated devices that are only in storage and are not in use. Old batteries can leak and damage the device! Do not use rechargeable batteries! When inserting the battery, make sure the polarity is correct. Using the battery incorrectly can damage the device! The Home Control Motion Sensor requires a commercially available CR123(A) lithium battery.
Add device devolo Home Control Motion Sensor. Follow the instructions in the Home Control portal for logging into your Home Control Central Unit. Installing the Home Control Motion Sensor Install the Home Control Motion Sensor on a flat and level surface so that the black release button on the rear of the sensor is depressed when the device is installed. Before permanently fastening the Home Control Motion Sensor at the desired location, test whether the sensor can be triggered.
If you use screws to attach the Home Control Motion Sensor, take apart the upper and lower housing component of the sensor by pressing the tab down in order to release the housing components (from top to bottom, and ). 쑗 Based on the template on the lower housing component, drill holes into the desired location and attach the lower component of the sensor using screws. 쑗 Insert the bottom end of the upper housing component into the groove provided for this purpose in the lower component.
Service and warranty Warranty: 3 years If your devolo device is found to be defective during initial installation or within the warranty period, please contact the vendor who sold you the product. The vendor will take care of the repair or warranty claim for you. The complete warranty conditions can be found at www.devolo.com/warranty. Great Britain 0203 024 18 38 (national rate) support@devolo.co.uk Sweden 0077 1400 480 (national rate) support@devolo.
40961/0115 devolo AG Charlottenburger Allee 60 52068 Aachen – Germany www.devolo.
