Technical data

Network configuration 65
devolo dLAN pro 500 Wireless+
Multiple VLANs can be assigned to the Ethernet ports
and the dLAN port.
Wi-Fi ports can be assigned only to a VLAN.
For detailed information about this, refer to
the online FAQs on our Internet site
www.devolo.com
.
If the Wi-Fi mode Access point is enabled, only the
access points are assigned to the VLANs. If the Wi-Fi
mode WLAN client is enabled, only the Wi-Fi client is
assigned to the VLAN.
The behaviour of the port is configured via the columns
Force Tx Untag, Acceptable Rx Frame Types (All/
Tagged only) and Default VLAN (ID):
쎲 If the option Force Tx Untag is enabled, all out-
going frames are sent from this port as
"untagged".
쎲 If the option Force Tx Untag is not enabled, all
outgoing frames are sent from this port as
tagged.
The factory defaults of the
dLAN pro 500 Wireless+ have the option
Force Tx Untag enabled, i.e. all frames are
sent "untagged".
쎲 The option Acceptable Rx Frame Types (All/
Tagged only) refers to the incoming data path of
the ports. It determines whether all frames i.e.
"tagged" and "untagged" (All) are accepted or
only "tagged" frames (Tagged Only). If the All
setting is enabled, all "untagged" frames are for-
warded to the VLAN with the Default VLAN (ID)
configured for this port.
쎲 Under Default VLAN (ID), the VLAN ID is speci-
fied, which is assigned to the received
"untagged" frames. In the setting Acceptable
Rx Frame Types (Tagged only), the configured
Default VLAN (ID) is insignificant.
쎲 Under Default Prio, the VLAN priority is speci-
fied, which is assigned to the received
"untagged" frames.
ETH 1 ETH 2 ETH 3