Operation Manual

|
Appendix
31
|
devolo dLAN Audio extender
|
5.1.2 Audio playback
No sound output
Effect:
No sound.
Possible causes:
쎲 The volume of your stereo system or active loudspeakers is turned down or
muted.
쎲 The audio cable is not plugged in or slipped out.
쎲 The audio cable is connected to a different input or an output of your stereo
system or active loudspeakers.
쎲 The sound of your computer is turned down or muted, e.g. in the Windows
volume control.
쎲 The sound output was not switched to the dLAN Audio extender, but is still
switched via the PC sound card.
쎲 The dLAN is not correctly configured.
쎲 The transmission speed in the dLAN is too slow.
Solutions:
쎲 Turn the volume higher at the output device or switch muting off.
쎲 Check whether the audio cable is plugged into the correct sockets at both
ends.
쎲 In Windows XP, call up the volume control via start ! Control Panel !
Sounds and Audio Devices ! Volume ! Device volume ! Advanced.
Ensure that both Volume Control and Wave are not turned all the way
down and that the Mute check boxes of these two channels are not dis
-
abled.
쎲 Check whether the devolo dLAN Audio extender Control software is
loaded (identified by an icon consisting of a note with a loudspeaker in the
Windows system tray at the bottom right on the taskbar) and the output is
redirected to the devolo Audio extender sound driver (right-click on the
application icon, then Select default audio device).
쎲 Check whether your dLAN functions properly.