Technical data

Connection and Startup

devolo dLAN 200 AVpro i

If no device that is switched on (e.g. computer) is connected to the Ethernet port,

the dLAN 200 AVpro i switches to Power Save mode after about 20 minutes

(Power LED flashes). In Power Save mode, the dLAN

200 AVpro i cannot be

accessed via the power supply grid or the coaxial network. As soon as the device

that is connected to the Ethernet port is switched on again, your

dLAN

200 AVpro i is available again via the power supply grid or the coaxial

network.

ETH This is the connection point on the dLAN 200 AVpro i for con-

necting it to a computer or another network device with the

network cable (included).

The Auto-MDI(X) interface in the dLAN 200 AVpro i automati-

cally detects when a contact is seized and determines the trans-

mission rate of the connected network device.

Coax Here you connect the dLAN 200 AVpro i to the coaxial connec-

tor using the coaxial cable supplied.

Coax/Hybrid The switch must have been set to "Hybrid" to allow transmis-

sion across the power supply grid.

The switch must have been set to "Coax" to allow transmission

across the coaxial network.

AC Here you connect the dLAN 200 AVpro i to the power supply

using the power cable (included).