Product manual

devolo dLAN 200 AVpro host
10
Configuration
green. While the system is trying to connect the device, the device is marked
yellow. If the connection fails, finally the device is marked red.
If a device is connected, you can do the following by pressing the
appropriate buttons:
stop device: disconnects the device; after a short while, the device is
disconnected and marked orange.
select profile: selects and applies a configuration profile for this
device. While the system is writing the configuration to the device, it is
marked yellow.
SNR graph: shows the SNR graph for the connection to this device.
This button is disbled until data has been transferred to or from the
corresponding device.
reset device: resets the dLAN part of this device.
remove from list: disconnects the device and removes it from the
control list.
Management of remote devices is only possible if
• the isolation of neighbouring devices is disabled at the dLAN 200
AVpro host (default setting under Overview > Network
configuration > Isolation from neighbouring devices). Thus,
the dLAN 200 AVpro host will be member of a peer-to-peer
network
• the dLAN 200 AVpro host is configured as master of a master/slave
network (set as master under Overview > Network
configuration > Isolation from neighbouring devices).
Management of remote devices is not possible, if the dLAN 200 AVpro host is
configured as a slave!