Specifications

dLAN 200 AVmodule 6400
12
devolo AG
Charlottenburger Allee 60 Tel.: [phone] www.devolo.com
D-52068 Aachen Fax: [phone] [e-mail]
minimum period for MII_MDCLK is 400 ns.
29
30
MD_A3
MD_A4
MII Management Address.
The PHY Controller
samples M_A[4:3] during reset to set the MII
Management address; the valid addresses are
0x00, 0x08, 0x10 & 0x18.
-* I
Control 9 LINE_SYNC AC line zero-cross detect signal I I
LEDs 36 LED_PWR Indicates Power Good (default setting) O O
19 GPIO9 Indicates Ethernet link and activity
, strap to low
for proper boot configuration
I/O I/O
20 GPIO10 Indicates Powerline Link Status (red LED),
strap to high for proper boot configuration
I/O I/O
Host
Mode
Select
37 GPIO8 Indicates Powerline Link Status(green LED),
configures Host Mode:
0 = PHY Mode; 1 = Host/DTE Mode
I/O I/O
Reset 35 RESET Resets all module logic when low I I
AFE 39
40
41
42
TX
TXn
RXn
RX
Analog Transmit Output
Analog Transmit Output (complementary)
Analog Receive Input (complementary)
Analog Receive Input
O
O
I
I
O
O
I
I
Power &
Ground
7,18,28,38 Ground Ground Reference I I
5,6 V
CORE
+1.05V with respect to ground I I
33,34 V
DD
+3.3V with respect to ground I I
43 V
AA
+11V with respect to ground I I
Duplex
Select
1 DUPLEX Not connected, Function is not supported by
INT6400 based module
-* I
Speed
Select
2 SPEED Determine MII interface rate:
0 = 10 Mbps; 1 = 100 Mbps
-* I
Isolate
Mode
Default
Value
3 ISODEF Determine default mode for MII Bus:
1 = isolate; 0 = normal operation
-* I
Auto
Negotiati
on
Enable
4 ANEN Control auto negotiation capability:
1 = enable auto negotiation; 0 = use the speed
and duplex selects
-* I
Pushbutt
on
8 Pushbutton Connector for pushbutton signal I I
Table 12: dLAN 200 AVmodule 6400 pin description by group
* - for proper connection in MAC mode see
table 7