User Manual
Table Of Contents
- devolo_Magic_2_LAN_triple.pdf
- Contents
- 1 Preface
- 2 Introduction
- 3 Initial use
- 4 Network configuration
- 5 Appendix
- Index
Network configuration 34
devolo Magic 2 LANtriple
To do so, enter the desired new password twice.
The web interface is now protected against un-
authorized access with your custom password!
4.6.3Identify Device
The devolo Magic adapter can be located using the
Identify device function. Click Identify to make
the white LED for the corresponding adapter flash
for 2 minutes to make it easier to identify by sight.
4.6.4LED
Enable the LED disabled option if the LED on the
devolo Magic adapter is intended to be switched
off for normal operation. An error status is indica-
ted by corresponding flashing behaviour regard-
less of this setting.
4.6.5 Powersaving
If powersaving mode is enabled, the
devolo Magic 2 LAN triple switches to powersa-
ving mode automatically whenever it detects re-
duced data transmission over Ethernet.
The latency (time for transmitting a data
packet) may be negatively affected.
Powersaving mode is disabled in the
devolo Magic 2 LAN triple factory default settings.