User Manual
Table Of Contents
- devolo_Magic_2_LAN_1-1.pdf
- Contents
- 1 Preface
- 2 Introduction
- 3 Initial use
- 4 Network configuration
- 5 Appendix
- Index
25 Initial use
devolo Magic 2 LAN 1-1
3.5 Removing the devolo Magic
adapter from a PLC network
To remove a devolo Magic adapter from your net-
work and successfully restore its entire configurati-
on to the factory default settings, press the PLC/
reset button longer than 10 seconds.
Wait until the LED flashes white and then dis-
connect the adapter from the power supply.
Be aware that this loses all changes to all set-
tings!
To integrate it into another network, proceed as
described in Chapter 3.3.2 Single Adapter—Ex-
panding an existing PLC network by adding
another devolo Magic 2 LAN 1-1.