User manual

components panel or master volume)
Also try to set Treble and Bass to
normal levels.
Speaker can not be placed on a
speaker stand
Tightening knob is turned too tight Loosen tightening knob
Stand not suitable Measure stand top diameter, this
should be around 33-36 mm for
optimal placement. Use another
speaker stand if needed.
Buzzing noise coming from the
speaker
Ungrounded power connection Connect the speaker to a
grounded outlet
Ungrounded signal source Connect the signal source to a
grounded outlet
Interference from power cables Avoid placing power and signal
cables in a parallel structure
Bad cables Remove the cable or
increase/decrease the volume of
the speaker. If the noise is gone,
the problem is somewhere in your
signal chain.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 2.0 Creation date + author initials: 22-04-2013 RV Revision date + author initials: 25-02-2014 RV