Specifications

7
INSTALLATION
Important : To ensure that this equipment reaches you in first class condition,
protective coatings have been used. Flush the equipment through with
appropriate solvent before use.
Fix the spray gun using mounting stem ref.28 and secure it with nut ref.29.
HOSES
Use separate filtered regulated air supplies for atomizing and cylinder air. Connect the cylinder air
‘CYL AIR’ on top of the body via a control valve. For fast cylinder operation the control valve should
be fitted as close to the gun as possible or an additional quick exhaust valve installed in the line.
Attach atomizing air hose to the inlet threaded hole ‘FAN & ATOM AIR’ under the gun body.
Connect material hose(s) ‘P’ to the spray head. If material re-circulation is required, remove plugs
(30) & (32). Fit standard connector (¼” BSP) to the spray head.
Recommended hose size up to 10m (34ft) long :
Atomization Air : 8mm, Cylinder Air : 6mm, Material : 9,5mm
A Adjusting knob
B Sprayhead
C Air cap Retaining Ring
D Air Cap
E Valve (Fan and atom)
F Body
P Product inlet/ outlet
G Fluid tip
Important : The Spray gun must be earthed to dissipate any electrostatic
charges which may be created by fluid or air flows. This can be achieved
through the Spray gun mounting, or conductive air/fluid hoses. Electrical
bond from the spray gun to earth should be checked with an ohmmeter. A
resistance of less than 10
6
Ohms is recommended.