Specifications

10
Disconnect tool from air supply before adjusting,
clearing jams, servicing, relocating and during non-
operation.
LOADING THE TOOL
1. Disconnect air supply.
2. Pull back on the fastener pusher until locked.
3. Insert a stick of fasteners into the slotted opening in
top of the magazine. Make sure the pointed ends of
the fasteners are loaded with the points down. Also
make sure fasteners are not dirty or damaged. Use
DeVilbiss fasteners or equivalent for proper fastener
performance.
4. Squeeze the pusher and latch together to release the
pusher.
Handle the tool carefully, respect the tool as a working
implement and always assume the tool contains
fasteners:
a. Never use the tool as a toy and engage in horse-
play.
b. Never aim or point the tool at anyone. The tool
may contain fasteners.
c. Always keep people and animals at a safe distance
from the work area in case of accidental discharge
of fasteners.
d. Never pull the trigger unless the nose of the tool
is
against the work surface.
e. Do not pull the trigger or depress the contact trip
when loading the tool.
Protect your eyes and ears. Wear Z87 safety glasses
with side shields. Wear hearing protection. Employ-
ers and users are responsible for ensuring the user or
anyone near the tool wear this safety protection.
READ THIS MANUAL AND UNDERSTAND ALL
SAFETY WARNINGS AND INSTRUCTIONS BE-
FORE OPERATING TOOL.
OPERATING THE TOOL
NOTE
Check and replace any damaged or worn components
on the tool. The safety warning labels on the tool must
also be replaced if they are not legible.
Disconnect tool from air compressor before adjust-
ing, clearing jams, servicing, relocating and during
non-operation.
Never place your hand, or any part of your body, in the
fastener discharge area of the tool when air supply is
connected to the tool. Serious personal injury may
occur.
NOTE
Use DeVilbiss Air Power fasteners or equivalent for
proper performance of tool. See page 15 for fastener
information.
STEP 1
STEP 3STEP 2
STEP 4