Operating instructions

7—ENG
OPERATING INSTRUCTIONS
START-UP
1. Attach middle extension to gun/hose assembly by
inserting the thread end and hand tighten.
2. Insert high pressure hose into pressure washer
outlet port and hand tighten.
3. Connect garden hose to the pressure washer inlet
port. Make sure the screen is free of any debris.
4. Turn on water supply, then release trigger safety,
pull trigger to remove any trapped air in the system
(about 15 seconds). Verify that there are no water
leaks.
5. Verify that the pressure washer switch is in the "Off"
position. Plug the power cord into the G.F.C.I.
Protected outlet. (Push reset on G.F.C.I.).
6. Assemble proper wand/accessory into the end of
the middle extension wand by pushing in and
rotating 90º until it locks into place.
7. Switch to "On" position.
8. Verify that trigger lock is disengaged. When
engaged, the trigger cannot be operated. This
eliminates unauthorized use of the gun by small
children, etc.
9. You are now ready to use your pressure washer.
NOTE: The unit will stop automatically when
the trigger is released and will start when the
trigger is pulled.
OPERATION
1. For high pressure cleaning, attach rotary nozzle to
middle extension wand (see #6 in Start-up).
2. For applying detergents, attach detergent nozzle
and place hose end/filter assembly into fluid
container. When using detergents, it is best to give
them time to work (3 to 5 minutes) before high
pressure rinse.
SHUT-DOWN
1. Turn off the water supply.
2. Pull the trigger for 2 to 4 seconds to remove
remaining water from the hose and pump.
NOTE: (This should be done quickly). Unit will
continue to run without the water connected
to your pressure washer.
3. Turn switch off and unplug.
4. Disconnect garden hose.
5. Rinse detergent screen with water.
6. Store unit according to "Maintenance and Storage."
See page 8.
Operating unit with water supply shut off (without flow of water) will result in equipment damage.
During shut-down, entire system including pump, hose and wand will remain under pressure.
Do not attempt to remove hose/gun until pressure is relieved.
The trigger lock does not lock the trigger of the gun during operation
but only prevents unit from being used unintentionally.