Instruction manual

- 16 -
OSD Architecture
CVBS Setup (Picture)
Brightness 50
Contrast 50
Saturation
60
Hue 50
Sharpness 0
Back Light [ Strong ]
Exit OSD ▼▲
Picture CVBS1
Press Enter Key and the OSD MENU pop up.
Press Arrow Down or Arrow Up Key to move cursor to
then press Enter to
access the CVBS Setup.
Move Arrow Down and Arrow Up Key to adjust the values of each selection.
Press Enter key to confirm the change and move to the next selection.
Press Enter key to “Exit OSD” and press Arrow Down or Arrow Up Key to
Exit the OSD MENU.
 Brightness: Adjust the overall picture shade and brightness.
 Contrast: Permits adjustment for contrast between light or dark areas of the
picture.
 Saturation: Adds coloring to the black and white picture content (of a color
signal), and is usually set for viewer’s preference in color
saturation.
 HUE: Adjusts all the colors on the screen, but is most noticeable to the
eye in reds and yellows, and is also usually set for pleasing face
tones (NTSC only).
 Sharpness: Sets the desired sharpening enhancement to the picture.
 Backlight: This feature is designate to directly adjust the backlight levels of
LCD panel in case the unnecessary light condition should hinder
the viewing of the images. Press Arrow Down or Arrow Up Key to
adjust.
(i.e. the LCD monitor is installed on a strong-lighted office or
surveillance center). [Strong]or [Weak] selectable.