User's Manual

7/7/2017 Page 7(8)
Device Solutions Inc
Proprietary & Confidential
http://www.device-solutions.com/
Phone/Fax: [phone]
4.4 Secure enclosure base to enclosure
- #4-20, 3/8 T10 screws (HW0006)
Place the enclosure base on the table (shown below), while ensuring the O-ring is still in place turn the
enclosure top over and set in place. There are tabs in corners of the enclosure top and bottom, be sure
to line these up properly for a good fit. Using the #4 screws that are 3/8 inch long T10 screws, secure the
enclosure base to the enclosure top (tighten the screws to 7-8 inch-pounds of torque).