User's Manual

Athalon

CM & Crixus™ User Manual

The cabling used to connect the external DC supply to the Wi-Fi Gateway DC

power connector must comply with Article 725 of the NEC for Class 2 circuits.

1.2.1.5. Power Supply Installation

(TBD)

1.2.1.6. Technical Specifications

1.2.2. Fluid Interface

1.2.2.1. Description

The Athalon

CM Fluid Interface is a wall mounted electrical enclosure equipped

with circular M8 connectors for the flexible cords connecting the process sensors.

The Fluid Interface allows the end user to mount process sensors in a section of the

system operating below 20 bar. The process sensors are equipped with SAE 1926-

1 compliant diagnostic tee fittings allowing the sensors to be easily installed in end

user piping systems.

1.2.2.2. FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) his device must accept any interference received, including interference that

may cause undesired operation.

The Fluid Interface does not contain any user-serviceable parts. Changes or

modifications not expressly approved by Pall Corporation could void the user's

authority to operate the equipment.

Functional Description

Specification/Range

Node communication

915 MHz LoRa Radio

WiFi network adapter

WiFi access point, 100m theoretical distance

Ambient Temperature

-25 – 60°C (-13 – 140°F)

Power requirement.

24VDC, 200mA

Ingress Rating Electronics

IP65 Minimum

802.11 Supported Protocols

2.4 GHz Wi-Fi 802.11 a/b/g/n

WiFi Authentication types

Open (no security), WEP-40, WEP-104, WPA (AES & TKIP), WPA2

(AES, TKIP & Mixed mode)