User's Manual

Athalon

CM & Crixus™ User Manual

The Athalon

CM Filter Node is a Athalon housing mounted, electrical enclosure

equipped with a circular M8 connector for the flexible cord connecting the dP

Sensor. The Filter Node also connects to the lid mounted RFID antennae via

inductive coupling.

1.2.4.2. FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) his device must accept any interference received, including interference that

may cause undesired operation.

The Filter Node does not contain any user-serviceable parts. Changes or

modifications not expressly approved by Pall Corporation could void the user's

authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the

interference at his own expense.

This device uses RF energy to communicate. To reduce RF Exposure, this device

must be installed in a manner to ensure at least 20cm separation is maintained

between the device antenna and the body of the user or nearby people.

1.2.4.3. ISED (Canada) Notice

The device complies with Industry Canada’s license-exempt RSSs. Operation is

subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Cet appareil est conforme aux normes d’exemption de licence RSS d’Industry

Canada. Son fonctionnement est soumis aux deux conditions suivantes: (1) cet

appareil ne doit pas causer d’interférence, et (2) cet appareil doit accepter toute

interférence, notamment les interférences qui peuvent affecter son fonctionnement.