User's Manual

10. Tighten the cable restraint nut to the cable
restraint. Note: The transducer cable must be
between 2.9 and 6.4 mm in diameter and must be
tighten to a torque of 25-30 inch lbs to avoid water
infiltration.
11. Attach the transducer wires to the terminal blocks.
This connection depends on the type of transducer
used.
12. Install the 9 volt battery in the sensor
13. Re-install the screws that hold the top of the
enclosure to the baseplate.
14. Attach the enclosure to a surface. The best RF
performance is obtained by mounting the Sensor
vertically.