User's Manual

FCC Interference Statement

Changes or modifications not expressly approved by Device Solutions could void the user’s authority to operate

this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

Cellular Gateway Installation

1. Using a Torx T10 driver, remove the four 3/8” #4

screws into the corners of the enclosure top that

fasten it to the enclosure base.

2. Connect the battery.

3. Reinstall the four 3/8” #4 screws into the corners of

the enclosure top that fasten it to the enclosure

base. The screws must be tightened to a torque of

8.2 +/-0.5 kgf-cm to ensure that the IP68 rating is

maintained.

4. Attach the enclosure to a surface. The best RF

performance is obtained by mounting the Gateway

to a vertical service.

5. Insert the external power plug into the jack and

tighten the locking ring. Failure to properly tighten

the locking ring will invalidate the IP68 rating of the

Gateway.