User`s guide

User's Guide
- 89 -
Use
To
Timeouts
Sleep Mode
Disabled
1–180 min
Set the amount of time the printer waits after a job is printed
before it goes into a reduced power state.
Notes:
• “30 min” is the factory default setting.
• “Disabled” appears only when Energy Conserve is set to
Off.
• Lower settings conserve more energy, but may require
longer warm-up times.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm-up time.
To wake the printer from Sleep mode, try one of the following:
• Press any hard button on the printer control panel.
• Open the front door of the printer.
• Remove paper from the standard bin.
• Send a print job from the computer.
• Load paper in the multipurpose feeder.
• Turn off the printer, and then turn it back on.