Data Sheet
3
Sheet No. : OP13003EN
GP2Y0E02A
■Absolute maximum ratings
Ta=25°C (unless otherwise specified)
■Recommended operating conditions
Parameter
Supply voltage
Storage temperature
Operating temperature
Input terminal voltage
Output current
Output terminal voltage
Symbol
VDD
Tstg
Topr
GPIO1
Iout (A)
Vout (A)
Unit
-0.3 to + 3.6
-40 to +70
-10 to +60
-0.3 to VDD+0.3
-6.0 to +6.0
-0.3 to +2.8
Ratings
V
°C
°C
V
mA
V
Remark
-
-
-
Refer to 3-4
-
-
Parameter
Supply voltage
GPIO1 Low level input
GPIO1 High level input
Symbol
VDD
VIL
VIH
Unit
2.7 to 3.3
Max. VDD x 0.3
Min. VDD x 0.7
Rating
V
V
V
Remark
-
Stand-by state
Operating state
GPIO1
Reflective
Object
10% @50cm 90% @4cm
Vout(A)
2.1[V] (spec min. @4cm)
2.3[V] (spec max. @4cm)
Ts (Max 40ms)
Vout(A) updated every 20ms after response time.
■Electro-optical Characteristics
(Ta=25°C, VDD =3V)
Parameter
Measuring distance range
Response time (Note 4)
Stand-by supply current
Output terminal voltage
Output terminal voltage
Output terminal voltage
Symbol
Ts
Icc2
Vout(A)3
Vout(A)2
Vout(A)1
MIN.
(Note 1)
L=50cm → L=4cm (Note 4)
GPIO1=GND
L=4cm (Note 1,2)
L=10cm (Note 1, 2)
L=50cm (Note 1, 2)
Conditions
4
-
-
2.1
1.9
0.3
MAX.
50
40
60
2.3
2.1
0.8
Average supply current Icc1 L=50cm, GPIO1=VDD - 36
L
※
TYP.
-
-
20
2.2
2.0
0.55
26
Unit
cm
ms
μA
V
V
V
mA
L : Distance to reflective object
※
(Note 1) Under dark condition
(Note 2) Using reflective object :
(Note 2) White paper (Made by Japan Color Research Institute order made color chart : mat, reflective ratio : 90%)
(Note 3) Max. time means that it takes time to stabilize output due to the change of reflected signal light.
(Note 3) Definition : the case that object condition is changed suddenly from the least reflection(max. gain condition in
(Note 3) internal circuit) to the most reflection (min. gain condition in internal circuit).
(Note 4) Method of measuring (Ts)
(Note 3) Connect GPIO1 with GND during measuring L=50cm with reflective object:
(Note 3) Gray paper (mat, reflective ratio : 10%).
(Note 3) After changing the position (L=4cm with reflective object: White paper (mat, reflective ratio : 90%),
(Note 3) Measuring the time of the output terminal : Vout(A) until stabilizing .