Documentation

Accessing the ETH008-B from your browser

Having plugged in your 12vdc power supply and Ethernet connection the board will power up and request an IP

address from the dhcp server, if no server is present then the board will default to IP address 192.168.0.200. Now

please start up your web browser and type http://eth008 into the address bar, please note this only works in Windows.

You will be prompted for a password as shown below:

The default login is:

Username: admin

Password: password

The ability to change these

settings is shown in the

configuration section

You should now see the following web page:

This web page will allow you to switch the relays on and off by clicking the relay buttons (the red/gray circles). It also

contains a links to this technical documentation page, network configuration and MQTT configuration.