User Manual
Table Of Contents
- Overview
- Control Protocols
- WiFi
- Configuration
- USB Configuration Commands
- ST Status. Return the system status
- RB ReBoot.
- IP Sets the modules IP address.
- SB Sets the SuBnet mask.
- GW Sets the GateWay address.
- PD Sets the Primary DNS.
- SD Sets the Secondary DNS.
- SS This sets the SSID.
- PW Sets your networks WIFI password.
- PA Sets the TCP/IP port number for the ASCII commands.
- MS Sets the MQTT broker address
- MD Sets the MQTT ID for this module
- MP Sets the MQTT broker’s port.
- R1-R8 Sets the MQTT topic this relay is subscribed to.
- N1-N8 Sets the MQTT topic this Input will publish to.
- TCP/IP Commands.
- HTML Commands.
- Webpage
- Schematics
- PCB dimensions
- Notes
ESP32SR88 User Manual v1.00
RB ReBoot.
This will restart the module. It may produce a lot of random characters as the
ESP32’s boot logging runs at a different baud rate. If it succeeds in connecting to your
network it will report the IP address.
Re-Booting.. .
⸮⸮⸮⸮⸮⸮⸮⸮崳 #XL###C 5)5) ia b⸮⸮⸮⸮⸮ ⸮⸮⸮ ⸮ ⸮⸮⸮⸮⸮⸮⸮⸮奅#UY⸮ o⸮⸮⸮⸮⸮⸮##i#U⸮5*
Q⸮ ⸮⸮⸮⸮⸮
WiFi connected.
IP address:
192.168.0.6
IP Sets the modules IP address.
Enter IP followed by the required IP address. Entering address 0.0.0.0 means the IP will be
obtained from your networks DHCP server. The new IP address will take effect after the
next re-boot.
IP “192.168.0.123”
OK. Saved IP Address: 192.168.0.123
SB Sets the SuBnet mask.
SB “255.255.255.0”
OK. Saved Subnet Mask: 255.255.255.0
GW Sets the GateWay address.
This is normally the IP address of your router.
GW “192.168.0.1”
OK. Saved Gateway Address: 192.168.0.1
Copyright © 2020, Devantech Ltd.
All rights reserved.
www.robot-electronics.co.uk
5