Instruction manual

1. PRESSURIZED DEVICES:
This equipment is a pressure containing device.
Do not exceed maximum operating pressure as
shown on equipment serial number tag.
Make sure equipment is depressurized before
working on or disassembling it for service.
GENERAL SAFETY INFORMATION
2
2. ELECTRICAL:
This equipment requires electricity to operate.
Install equipment in compliance with all
applicable electrical codes.
Standard equipment is supplied with electrical
enclosures not intended for installation in
hazardous environments.
Disconnect power supply to equipment when
performing any electrical service work.
RECEIVING, MOVING, AND UNPACKING
A. RECEIVING
This shipment has been thoroughly checked, packed
and inspected before leaving our plant.
It was received in good condition by the carrier and
was so acknowledged.
Check for Visible Loss or Damage.
If this shipment shows evidence of loss or damage at
time of delivery to you, insist that a notation of this
loss or damage be made on the delivery receipt by
the carrier’s agent.
B. UNPACKING
Check for Concealed Loss or Damage.
When a shipment has beendelivered to you in
apparent good order, but concealed damage is
found uponunpacking, notify the carrier
immediately and insist on his agent inspecting the
shipment.
Concealed damage claims are not our responsibility
as our terms are F.O.B. point of shipment.
C. MOVING
In moving or transporting dryer, do not tip dryer
onto its side.
D. STORAGE
IMPORTANT - Do not store dryer in temperatures
above 130°F, 54.4°C.
3. BREATHING AIR:
Air treated by this equipment may not be suitable
for breathing without further purification.
Refer to applicable standards and specifications for
the requirements for breathing quality air.
For Sales or Service Call: 705-722-5747 Ext.1