Technical information

3
9929en
28
2
1
!
© 25 746 2
© 26 423 0
Engine Operation 3.2 Starting
3.2.1 Electric starting
Before starting, make sure that no-
body is standing in the immediate
vicinity of the engine or driven ma-
chine.
After repair work:
Check that all guards have been
replaced and that all tools have been removed from
the engine.
When starting with glow plugs, do not use any other
starter substance (e.g. injection with start pilot).
Risk of accident!
Caution: If the speed regulator has been re-
moved, the engine must not be tested under any
circumstances.
Disconnect the battery!
Do not actuate the starter for more than 20 sec-
onds. If the engine does not catch, wait a minute
then try again.
If the engine does not catch after two attempts,
refer to the Fault Table (see 7.1).
● Where possible, disengage clutch to separate
engine from any driven parts.
● Move speed control lever 1 into idle position.
● Move shut-off handle 2 into operating position.
Without cold start assistance
● Insert key
- Position 0 = no operating voltage
● Turn key clockwise
- Position 1 = operating voltage
- Pilot lights come on
● Push key in and turn further clockwise against
spring pressure.
- Position 2 = no function
- Position 3 = start
● Release key as soon as engine fires
- Pilot lights go out.