Specifications
Engine corrosion protection Transport and storage
© 2008 57
8
Bare exterior surfaces and parts
z
Coat or spray all bare exterior parts and surfaces
(e.g. flywheel, flange faces) with corrosion pro-
tection agent.
Rubber parts
z
Rubber parts (e.g. muffs) which are not painted
over must be rubbed down with talcum powder.
Belt drive
z
Remove V-belts and V-rib belts and store
packed.
z
Spray V-belt pulleys and tension rollers with cor-
rosion protection agent.
Engine openings
z
All engine openings must be fitted with air-tight,
water-tight covers to delay the vapourisation
process of the corrosion protection agents.
z
With installed air compressor, the suction and
pressure connection must be sealed by a cap.
z
Air should be excluded to avoid ventilation of the
engine (chimney effect) for the suction from an
air supply pipe.
Storage and packaging
z
After being protected against corrosion, the en-
gine must be stored in a dry, ventilated hall and
suitably covered.
z
The cover must be placed loosely over the en-
gine so that the air can circulate around it to pre-
vent condensation from forming. Use a desiccant
if necessary.
Removal of corrosion protection
z
The corrosion protection must be removed from
the corrosion protected engine before starting.
z
The packaging and all covers over the closed
openings must be removed.
z
Any corrosion deposits and paint damage should
be remedied.
Fuel system
If there is a mixture of diesel fuel/corrosion pro-
tection oil in the fuel tank, drain it.
z
Connect fuel/tank/supply line to the engine. Pay
attention to cleanliness.
z
Fill the fuel tank and fuel system with the proper
fuel.
Lubricating oil system
z
Unscrew the lube oil drain screw, drain oil.
z
Fill the engine with lubricating oil via the lubricat-
ing oil filler neck.
Removal of exterior corrosion protection
z
All areas and components coated with corrosion
protection agent must be washed off with dis-
tilled fuel or a suitable cleaning agent.
z
Wash out grooves of V-belt pulleys if necessary.
z
Mount V-belts or V-rib belts as specified.
z
Fill with coolant.
Corrosion protection agent / cleaning agent
Please ask your DEUTZ partner for reference prod-
ucts for the corrosion protection agents/cleaning
agents to be used which meet DEUTZ requirements.
or see www.deutz.com
\SERVICE \Operating Media and Diagnosis
OBJ_DOKU-16314-001.fm Seite 57 Donnerstag, 24. Juli 2008 11:18 11