Specifications

Fault table Faults
© 2008 53
7
Engine lubricating oil pressure is non-
existant or excessively low
Lubricating oil level too low Fill up lube oil
Excessive inclination of engine Check engine mounting / reduce inclination
Wrong SAE viscosity class of the engine lubricating oil Change the lubricating oil
Injection line leaks Check injection line
Injection valve defective Check fuel injector / change if necessary
Lube oil cooler defective Check/replace
Compression pressure too low Check the system
Air in fuel system Vent fuel system
Engine lubricating oil consumption
excessive
Lube oil level too high Check lube oil level, if necessary drain off.
Excessive inclination of engine Check engine mounting / reduce inclination
Air filter clogged / turbocharger defective Check/replace
Lubricating oil in the exhaust system Engine operated continuously with too low a load (< 20-30%) Check load factor
Engine producing blue smoke Lube oil level too high Check lube oil level, if necessary drain off.
Excessive inclination of engine Check engine mounting / reduce inclination
Engine producing white smoke Below starting limit temperature Check
Lube oil level too high Check lube oil level, if necessary drain off.
Incorrect valve clearance Check valve clearance and set if necessary
Fuel quality does not comply with operating manual Change the fuel
Compression pressure too low Check the system
Cold starting device Check/replace
Injection valve defective Check fuel injector / change if necessary
Faults Causes Measures
OBJ_DOKU-16314-001.fm Seite 53 Donnerstag, 24. Juli 2008 11:18 11