Specifications

Lubricating oil system Servicing and maintenance works
© 2008 33
6
Regulations for working on the lubricating oil
system
Do not work when the engine is running!
Smoking and naked lights prohibited!
Be careful of hot lubricating oil. Danger of
scalding!
Pay attention to utmost cleanliness when
working on the lubricating oil system. Clean
the area around the components con-
cerned carefully. Blow damp parts dry with
compressed air.
Observe the safety regulations and nation-
al specifications for handling lube oils.
Dispose of leaking lubricating oil and filter
elements properly. Do not allow used oil to
seep away into the ground.
Perform a trial run after all work. Pay atten-
tion to tightness and lubricating oil pressure
and then check the engine oil level.
In case of fuels containing more than 1%
sulphur, contact your corresponding
DEUTZ partner.
Checking the lubricating oil level
z Pull out the lubricating oil dipstick and wipe off
with a lint-free, clean cloth.
z Insert the lubricating oil dipstick as far as it will
go.
z Extract the lubricating oil dipstick and read off the
oil level.
Low lubricating oil level and overfilling lead
to engine damage.
The lubricating oil level may only be
checked with the engine in a horizontal po-
sition and switched off.
If the engine is warm, switch off the engine
and check the lubricating oil level after 5
minutes. If the engine is cold you can check
it immediately.
Be careful of hot lubricating oil. Danger of
scalding!
OIL ?
OIL
!
+80°C
+176°F
z The oil level must always be between the MIN
and MAX marks! Top up to the MAX mark if nec-
essary.
Changing the lubricating oil
z Warm up the engine (lubricating oil temperature
>80°C).
z Ensure that the engine or vehicle is in a level po-
sition.
z Switch off the engine.
z Place a collecting receptacle underneath the
lube oil drain screw.
z Unscrew the lube oil drain screw, drain oil.
z Fit a new sealing ring to the lube oil drain screw,
insert and tighten. (tightening torque 100 Nm).
z Pour in lube oil.
– Quality/viscosity data (
 26).
– Filling volume (
 58).
z Check lubricating oil level, if necessary top up.
OBJ_DOKU-16314-001.fm Seite 33 Donnerstag, 24. Juli 2008 11:18 11