Workshop Manual

5/6

TCD 2015

Drive system

W 02-01-07

Checking the rotation

z Mount magnetic measuring stand.

z Insert dial gauge.

z Apply stylus to the main bearing pin with pre-tension

(arrow) and adjust dial gauge to "0".

z Turn crankshaft evenly and check rotation.

 P02 26

z Remove magnetic measuring stand.

z Remove dial gauge.

Measuring the fit bearing width

z Set micrometer gauge to 38 mm.

z Push the internal measuring device between the test

surfaces of the micrometer gauge and set to "0".

z Measure bearing width with internal measuring de-

vice between thelay-on surfaces of the thrust rings.

 P02 11

P02 12

P02 13