Workshop Manual

TCD 2015

Drive system

W 02-01-04

2/2

z Measure locating bearing width

z Note measured value, dimension (a).

 P02 11

P02 12

P02 13

z Place thrust ring halves on bearing caps (arrows).

z Measure width with micrometer gauge.

z Note measured value, dimension (b).

z Determine axial backlash.

 P02 34

Calculation example

Desired: Axial backlash

Given: -

Measured: (a) = 38.6 mm

(b) = 38.4 mm

Calculation: Axial backlash = dimension (a) - dimension (b)

38.6 mm - 38.4 mm

Result: =0.2mm

With deviating axial backlash:

Set axial backlash by changing the thrust

ring halves.

z Install crankshaft.

 W 02-04-01