Workshop Manual

© 06/2006 8219-001
1/6
TCD 2015
Fuel system
W 07-07-01
6
Removing and installing the fuel injectors
Commercial available tools:
– Assembly pliers. . . . . . . . . . . . . . . . 8024
Special tools:
– Puller. . . . . . . . . . . . . . . . . . . . . . 110030
– Grooved nut wrench . . . . . . . . . . 110130
– Disassembly tool. . . . . . . . . . . . . 110901
– Extraction tool. . . . . . . . . . . . . . . 120660
– Slide hammer . . . . . . . . . . . . . . . 150800
– Plugs/caps . . . . . . . . . . . . . . . . . 170160
– Fitting compound
DEUTZ S1
– W 07-03-01 . . . . . . . . . . . .(A-bank)
– W 07-03-01 . . . . . . . . . . . .(B-bank)
– W 07-07-05
Danger!
Wait 30 seconds after switching off the
engine before working on the fuel system.
Attention!
Pay attention to utmost cleanliness when
working on the fuel system.
Remove residue paint and particles of dirt
before removing.
Clean the respective affected parts care-
fully. Blow damp areas dry with compres-
sed air.
Observe the safety regulations and natio-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia-
tely before assembling.
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
Removing fuel injector
z Removing high pressure pipes (A-bank).
 W 07-03-01
z Removing high pressure pipes (B-bank).
 W 07-03-01
© 40957-0