Workshop Manual

TCD 2015

Fuel system

W 07-06-04

4/14

z Mount dial gauge holder (1).

z Tighten screws (2).

 A07 012

z Insert dial gauge holder (1) with stylus extension.

z Mount stylus with 6 mm pre-tension on the roller tap-

pet.

z Turn the crankshaft alternately in and against engine

direction.

z Check installation position of the dial gauge.

z Adjust dial gauge to "0".

Dial gauge must run on the base circle of

the injection camshaft.

The display of the dial gauge may not

move.

z Set crankshaft with turning gear in engine direction of

rotation (arrow) to ignition TDC, cylinder no. A1.

The locking pin of the turning gear must

snap into the starter gear ring.