Workshop Manual

© 06/2006 8215-001
1/6
TCD 2015
Fuel system
W 07-03-01
6
Renewing injection pipes
(B-bank)
Commercial available tools:
– Dog wrench. . . . . . . . . . . . . . . . . . . 8018
Special tools:
– Plugs/caps . . . . . . . . . . . . . . . . . 170160
– W 06-02-03
Danger!
Wait 30 seconds after switching off the
engine before working on the fuel system.
Attention!
Pay attention to utmost cleanliness when
working on the fuel system.
Remove residue paint and particles of dirt
before removing.
Clean the respective affected parts care-
fully. Blow damp areas dry with compres-
sed air.
Observe the safety regulations and natio-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia-
tely before assembling.
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
Injection pipes may not be bent.
Removing injection pipes
z Remove the charge air pipe.
 W 06-02-03
z Unscrew screws (1).
z Remove cylinder head cover (2).
z Remove gasket.
1
2
1
© 40791-0