Workshop Manual

3/6

TCD 2015

Drive system

I 02-03-03

z Align the pneumatic press horizontally on the base

plate.

The press-out die is in the centre above

the top of the assembly tool.

z Press out the small end bush with slight pressure.

z Clean the bush bore.

The bush bore must be free from grease

and dirt.

Installing small end bush

z Insert big end bearing holder (3) in base plate (2).

z Insert installation gauge (1) in base plate.

The groove (arrow) must face the big end

bearing holder.

Make sure the installation gauge is inser-

ted flush.