Workshop Manual

TCD 2015

Drive system

I 02-03-03

2/6

z Insert the bottom part of the assembly tool (3) into the

removal gauge from below.

z Place the connecting rod (1) on the base plate.

z Turn the bottom part (3) into the top part (2) of the as-

sembly tool.

The flat side (arrow) of the connecting rod

must face down.

z Align the top part (1) of the assembly tool and remov-

al gauge (2).

The top part of the assembly tool and the

removal gauge are level with the angled

surfaces (arrows) of the big end bearing.

z Screw the top part (1) and bottom part (2) of the as-

sembly tool together.