Workshop Manual

7/10

TCD 2015

Drive system

W 02-03-01

z Insert internal measuring device.

z Balance the internal measuring device at the given

measuring points and read off the measured value at

the reversal point of the pointer.

z Note measured value, dimension (a).

 P02 52

P02 54

If the values up to maximum 0.015 mm are

above the bearing tolerances, the connec-

ting rod can still be used.

When the limit value is reached, the con-

necting rod must be replaced.

Checking the diameter of the lifting jour-

nals

Diagram for measuring the journals at the

points 1 and 2 in the levels a and b.

z Measure lifting journal with micrometer gauge.

 P02 22

P02 23

P02 25

z Note measured value, dimension (b).

Measuring points see diagram.