Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21754-001.fm
1/4
6
Cylinder liner
TCD 2013 2V W 04-01-02
Testing the cylinder liner
Standard tools:
Micrometer gauge
Internal measuring device
Special tools:
Dial gauge 100400
W 04-01-01
W 06-01-01
W 08-03-01
The crankshaft bearing covers must be
mounted properly for measuring the
cylinders.
Testing the cylinder liner
Remove cylinder head.
W 08-03-01
Check cylinder liner for visible signs of wear.
Remove piston and connecting rod.
W 06-01-01
© 44074-0
Prepare internal measuring device:
Mount probe bolt for the appropriate measuring
range in the internal measuring device.
Mount dial gauge with approx. 1 mm pre-tension in
the internal measuring device.
Set micrometer gauge to 108 mm.
Balance the internal measuring device between
the test surfaces of the micrometer gauge and set
the dial gauge at the reversal point of the pointer to
"0".
© 36094-1