Workshop Manual

© 02/2010 OBJ_DOKU-21820-001.fm
3/6
6
Connection housing
TCD 2013 2V W 52-01-02
● Turn the crankshaft slowly to position (III).
● Read off measured value.
● Note measured value, dimension (b).
● Note the measured value (b) with the appropriate
sign on the measurement sheet.
Position (III)
Note the sign!
III
© 47691-0
● Turn the crankshaft slowly to position (IV).
● Read off measured value.
● Note the measured value, dimension (c).
● Note the measured value (c) with the appropriate
sign on the measurement sheet.
Position (IV)
Note the sign!
IV
© 47692-0
● Turn the crankshaft slowly to position (I).
● The dial gauge must indicate measured value "0"
again.
● Make the calculation according to the example in ta
-
ble 1.
In case of a radial run-out deviation above
the specified run-out limit value, the con
-
nection housing must be disconnected.
I
© 47688-0