Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21791-001.fm
1/6
6
Fuel pump
TCD 2013 2V W 20-02-01
Removing and installing the fuel supply pump
(V-belt drive)
Standard tools:
Hose clip pliers 8011
V-belt tension measuring
device 8115
Special tools:
Plugs/caps 170160
User notes
Operation manual
Danger!
Wait 30 seconds after switching off the
engine before working on the fuel system.
Attention!
Ensure utmost cleanliness when working
on the fuel system.
Carefully clean the area around the
affected parts. Blow damp areas dry with
compressed air.
Observe the safety regulations and natio
-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia
-
tely before assembling.
Collect leaking operating fluids in suitable
vessels and dispose of according to regu
-
lations.
After all work on the fuel system, it must be
bleeded - see the operation manual, chap
-
ter "6 Fuel system“.
Only test / tighten / renew V-belts with the
engine at a standstill.
The V-belt tension of new V-belts must be
checked after they have been running for
15 minutes.
Removing the fuel supply pump
Loosen screws (1).
Danger!
Wait 30 seconds after switching off the
engine before working on the fuel system.
Do not unscrew screws.
1
© 44037-1