Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21762-001.fm
1/8
6
Connecting rod
TCD 2013 2V W 06-01-02
Checking the con rod
Standard tools:
Micrometer gauge
Internal measuring device
Con rod test device
Rotation angle disc 8190
Special tools:
Dial gauge 100400
W 05-05-02
Checking small end bush
Prepare internal measuring device:
Mount probe bolt for the appropriate measuring
range in the internal measuring device.
Mount dial gauge with approx. 1 mm pre-tension in
the internal measuring device.
Set micrometer gauge to 42 mm.
Balance the internal measuring device between
the test surfaces of the micrometer gauge and set
the dial gauge at the reversal point of the pointer to
"0".
© 34768-2
Diagram for measuring the small end bush
at the points "a" and "b" in the
levels "1" and "2".
© 37239-1