Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21761-001.fm
1/8
6
Connecting rod
TCD 2013 2V W 06-01-01
Removing and installing the piston and con rod
Standard tools:
Rotation angle disc 8190
Special tools:
Piston ring compressor 130640
Liner holder 150180
W 07-02-02
W 08-03-01
W 16-01-01
Attention!
The assignment of con rod and big end
bearing cover must stay as it is. If con rod
and big end bearing cover are assembled
the wrong way around, the con rod will be
unusable!
Do not damage the fracture surfaces of the
con rod and big end bearing cover!
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
The engine oil and coolant should be
added according to the operating manual.
Removing the piston and con rod
Remove cylinder head.
W 08-03-01
Remove oil suction pipe
W 16-01-01
Mount liner holder (2).
Tighten screws (1).
Pull out oil dipstick.
1
1
2
© 44260-0