Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21760-001.fm
3/6
6
Crankshaft
TCD 2013 2V W 05-05-03
Remove crankshaft.
W 05-05-01
Set micrometer gauge to 38 mm.
Push the internal measuring device between the test
surfaces of the micrometer gauge and set to "0".
© 35825-2
Measure locating bearing width
Note measured value, dimension (a).
© 42606-0
Place thrust ring halves on bearing caps (arrows).
Measure width with micrometer gauge.
Note measured value, dimension (b).
© 35827-2