Workshop Manual

Table Of Contents
© 02/2010 OBJ_DOKU-21758-001.fm
7/12
6
Crankshaft
TCD 2013 2V W 05-05-01
Position camshaft.
Lightly oil bearing surfaces.
The bore (1) must be facing the cylinder
head.
1
© 44237-0
Insert the crankshaft carefully in the crankcase.
Set the crankshaft in line with the camshaft.
Attention!
Do not jam the con rods when inserting the
crankshaft!
Make sure that the markings match up.
© 44238-1
Check control times.
The marking (1) on the crankshaft flange
must be in line with your mark (2).
2
1
© 44446-0